How To Install Light Sensor On Outdoor Light

Installing a light sensor on an outdoor light is a great way to save energy and extend the life of your light bulbs. Light sensors work by detecting the amount of ambient light and automatically turning on or off your light accordingly. This means that your light will only be on when it is needed, which can save you money on your energy bill and help to reduce light pollution.

Installing a light sensor on an outdoor light is a relatively simple process that can be completed in a few minutes. However, there are a few things you need to keep in mind before you begin.

Materials you will need:

Light sensor
Screwdriver
Electrical tape
Wire strippers

Step-by-step instructions:

1. Turn off the power to the light fixture at the circuit breaker. 2. Remove the light bulb from the fixture. 3. Locate the wires that connect the light fixture to the power source. 4. Cut the wires about 6 inches from the light fixture. 5. Strip about 1 inch of insulation from the ends of the wires. 6. Connect the black wire from the light sensor to the black wire from the power source. 7. Connect the white wire from the light sensor to the white wire from the power source. 8. Connect the green wire from the light sensor to the ground wire from the power source. 9. Wrap electrical tape around the connections to secure them. 10. Insert the light bulb into the fixture. 11. Turn on the power to the light fixture at the circuit breaker.

Tips:

* When choosing a light sensor, make sure that it is compatible with the type of light fixture you have. * Place the light sensor in a location where it will be able to detect changes in ambient light levels. * Adjust the sensitivity of the light sensor so that it turns on and off at the desired light levels.

By following these simple steps, you can easily install a light sensor on an outdoor light and start saving energy today.